DN100
Klark Teknik
DN100
Klark Teknik DN-100 Active Direct Box
A ground-up redesign provides an extended dynamic range, lower noise floor and all the world-class audio performance you’d expect from Klark Teknik. DN100 is also designed to handle the rigours of life on the road: a thick aluminium shell protects the electronics, and this in turn is protected by a tough silicone rubber casing.
Dimensions: 5.6"L x 4.2"W x 2.35"H
Technical Tools
PDF Documents
Manufacturer Specs
INPUT
Type: Active electronic, balanced or unbalanced
Impedance
1M ohms nominal, balanced or unbalanced jack
20k Ω (XLR input only)
Connectors 1/4" jacks and one 3-pin XLR connected in parallel
Maximum Level +40dBu
OUTPUT
Type: Transformer isolated
Impedance: 300 Ω
Connector: 3-pin XLR
Maximum Level: +10dBu with load >2k Ω
Minimum Level: 600 Ω
Noise: -100dBu, 20Hz to 20kHz unweighted with input terminated by 50 Ω resistor
Frequency Response: +0.5dB/-1dB 20Hz to 20kHz
Distortion (THD+N): <0.01% @1kHz, +4dBu output
POWER REQUIREMENTS
Voltage: +48V Phantom*
Current Consumption: <10mA
* The DN100 has been designed to allow use at phantom voltages less than +48V.The unit will function down to +20V (when used with 6k8 dropping resistors) but with reduced headroom and dynamic range. All the specifications above are quoted using standard +48V phantom power.
Type: Active electronic, balanced or unbalanced
Impedance
1M ohms nominal, balanced or unbalanced jack
20k Ω (XLR input only)
Connectors 1/4" jacks and one 3-pin XLR connected in parallel
Maximum Level +40dBu
OUTPUT
Type: Transformer isolated
Impedance: 300 Ω
Connector: 3-pin XLR
Maximum Level: +10dBu with load >2k Ω
Minimum Level: 600 Ω
Noise: -100dBu, 20Hz to 20kHz unweighted with input terminated by 50 Ω resistor
Frequency Response: +0.5dB/-1dB 20Hz to 20kHz
Distortion (THD+N): <0.01% @1kHz, +4dBu output
POWER REQUIREMENTS
Voltage: +48V Phantom*
Current Consumption: <10mA
* The DN100 has been designed to allow use at phantom voltages less than +48V.The unit will function down to +20V (when used with 6k8 dropping resistors) but with reduced headroom and dynamic range. All the specifications above are quoted using standard +48V phantom power.