D2
Element Labs
D2
Versa®Drive Processor for Versa® TILE, Versa® TUBE, and Versa® RAY systems
This video processor converts a DVI video signal into serial data streams that drive Versa® TILE, Versa® TUBE, and Versa® RAY Systems. Through the use of a pixel map that is created in RasterMAPPER™ and downloaded into the Versa DRIVE, the D2 can map any incoming pixel data to any outgoing pixel
address.
The Versa DRIVE D2 also stores various system parameters and uses them in calculating the final output data. These parameters are set via RasterMAPPER or directly on the front panel of the Versa DRIVE.
address.
The Versa DRIVE D2 also stores various system parameters and uses them in calculating the final output data. These parameters are set via RasterMAPPER or directly on the front panel of the Versa DRIVE.
Dimensions: 19"W x 3.5"H x 12"D (rack mountable, 2 spaces high)
Technical Tools
PDF Documents
Manufacturer Specs
Front Panel
Power Switch
LCD Display
4 control buttons - Menu, Up, Down, Enter
Rear Panel
IEC - AC Power: 100-240 VAC 50/60Hz
4 x Serial Data output - for Versa TILE / TUBE
1 x Local Data output - for Versa TILE / TUBE
RS485 input for pixel map download and daisy-chaining (5-pin XLR)
RS485 output for daisy-chaining multiple D2 units together
Serial connector for pixel map download
DVI input: captures 1,024 x 768 60Hz display
DVI loop-out: allows for connection of DVI monitor or second Versa DRIVE D2 unit
Outputs
8,192 pixel output on Serial Data (2,048 per output)
2,048 pixel output on Local Data
30 FPS (frames per second) output rate
Mounting: Stand alone with plastic feet or rack mounted
Power Switch
LCD Display
4 control buttons - Menu, Up, Down, Enter
Rear Panel
IEC - AC Power: 100-240 VAC 50/60Hz
4 x Serial Data output - for Versa TILE / TUBE
1 x Local Data output - for Versa TILE / TUBE
RS485 input for pixel map download and daisy-chaining (5-pin XLR)
RS485 output for daisy-chaining multiple D2 units together
Serial connector for pixel map download
DVI input: captures 1,024 x 768 60Hz display
DVI loop-out: allows for connection of DVI monitor or second Versa DRIVE D2 unit
Outputs
8,192 pixel output on Serial Data (2,048 per output)
2,048 pixel output on Local Data
30 FPS (frames per second) output rate
Mounting: Stand alone with plastic feet or rack mounted